bros.

1. pirmi po ipag de-cock ang spring kan mga aegs ta para ma maintain su fps nya na mas haloy pag isasaray na.

firing in semi 3x is not a fool-proof way to relax the spring. its proven. the gears will continue to crank because there is still contact with the trigger switch when firing leaving the gun in firing position again.

the best way is to observe the spring on the hole of the cylinder. continue firing until the spring is 90-100% relaxed.

2. clean your inner barrel regularly with silicon oil and syempre su aeg man . don't use dirty bbs it will damage your inner barrel

3. properly charge/discharge your batteries. for lipo's don't charge over 4.2v per cell and don't discharge under 3v per cell or goodbye my precious!!

thank you sir sa tips.. pero pano yan na number 1? kaipuhan pa xa sir kalason?

hehehe.. siripon u lang tabi sir delta sa hole kung saen pigafeed an bb... tama baya tabi ako sir nivron?

@stormtroopr
you mean sir sa hopup chamber?
sad to say, dai masisirip ang position kang piston sa hopup chamber, coz nasa luwas na kang gearbox ang hopup chamber.. hehehe..

sad to say, there's no other way to check the piston's position other than disassembling it..

or...


kung muya talaga nindo naka relax ang spring all the time.. maski ano pa gibuhon nindo, pirmi yan ma relax..

REMOVE YOUR ANTI REVERSAL LATCH!!!

ma putok yan, pero may extra cranking sound ka pirmi madadangog every time you squeeze the trigger, that means nag babalik ang piston mo to relax position.. everytime na nag crank ang gears, and dai na complete su cycle, ma balik yan sa relax..

dont worry, iv'e tried it on my gun..

#1 applicable sa may type-2 cylinder buda dapat ma-expose mo su gearbox like sa m4/ak na dai ki extensive take-down kan aeg.

sa ak pwde halion su plastic cover sa may trigger para mailing su gears(bottom view)
dapat all gears kang sector gear nasa baba or partially. pag clear ang nailing mo meaning naka-engage sa piston body su ngipon kan sector gear so puro-pinki sna sa trigger buda timing lang.

http://www.airsplat.com/Images/mechbox_tutorial_4b.jpg

su suggestion ni sir lostwarrior pwde ito na alion su anti rev. latch. ang downside lang may diit na damage sa likod kan piston body ta na-slam ang ngipon kan sector gear pag na decompress ang spring. pero kadiit lang ito.